Juan Ramirez

  • Total activity 89
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 29

Articles

Recent activity by Juan Ramirez Recent activity Votes
  • DC-Sxxxx PTZ Series | How to change the preset Home position

    Environment DC-S3000 SeriesDC-S4000 SeriesDC-S6000 Series Procedure:Log in to the IDIS Recorder.Note: These steps can be done for the front panel console and from IDIS Center (Remote setup/DirectND...

  • DC-T4516WRX | How to factory default

    Environment:DC-T4516WRXPOE injector Issue:No email was set to reset the password.The password is unknown.No reset button next to the SD cardProcedure:Note: Before proceeding with the process, confi...

  • How to reboot the DR-Series/XDI Series from IDIS Center client

    Environment:DR-Series CRxx2XDI Series IDIS Center Client Procedure: Click on System>IDIS Center Setup>Device or Ctrl+Shift+D.Right-click on the Device and Select "Soft Reset"Press "Ok" to confirm.C...

  • IDIS Licensing Ordering Information

    Scroll down below to save the PDF Note: Check our IDIS Americas website for any updated information. Click hereIDIS Americas Licensing Quick Guide ISS Licensing IDIS VAI Licensing 

  • DR-Series | FEN Error " Device Name check failed!

    Environment:FEN setupProcedure:Getting a " Device Name check failed!" When checking the name.Go to Network>WAN and enter a valid "DNS" address.Click on the "Test" to confirm the DNS address is vali...

  • DC-T18A4WR | How to factory default

    Environment:DC-T18A4WRTool (IP scan) linked belowProcedure:Remove the cover to expose the Reset switch.With power on Hold for 5 seconds, then let go.Allow the camera to reboot, then run the IP scan...

  • IDIS DC-D4xxx | Enable and test audio

    Environment:  DC-D4538RA Built-in audio Added audio accessory IDIS Discovery software Procedure: Log in to the camera using the IDIS Discovery.Note: 1st time setup will prompt to create a password....

  • DC-D4000 Series | Speaker & Mic connection

    Environment:DC-D4218WRAAOP-SP-CF/AOP-SP-CS (speakerphone) 3rd partyAudio Alarm setupProcedure:Make all connections to the camera. (Mic/Speaker)Note: Refer to the AOP-SP-Cx manufacturer's manual for...

  • IDIS DR-Series | How to edit the layout display menu

    Environment: DR-Series  Purpose: To specify cameras that only need to be displayed or viewed. Procedure: Select the Layout icon located on the upper part of the screen. Select the screen that ...

  • DR-Series | How to rearrange cameras on the live monitor display..

    Environment: DR-1000 Series DR-2000 Series DR-3000 Series DR-6000 Series DR-8000 Series Located at the recorder.  Purpose: Cameras were added to the recorder in the wrong order.  Want the camera...